Penis Enlargment | Page 9

Not Available
minimum length. T\
hen loop the penis
head through the tubing and tighten by pulling from the other side. Care\
fully, pull the
Half-Pipe/Tubing assembly until the Turnbuckle hooks can be attached and\
screwed tight to
the Machine Screws in the Half- Pipe. This procedure takes about 1-3 min\
utes. Tension is
increased or decreased by twisting the turnbuckles. You may use a large \
metal paper binder
clip to hold the rubber tubing protruding from the back side of the Half\
-Pipe in place.
It is recommended that you wrap the glans and coronal groove of the peni\
s in about 20 cm
(8") of sterile Surgical Gauze for comfort, to reduce the chance of pi\
nching where PVC and
Tubing meet, to avoid sticking of tubing to sensitive skin after long st\
retch sessions, and for
hygiene.
During the first 2-3 weeks of your traction regimen, initial tension sho\
uld be no less than 0.6
kg (1.3 lb.) and no more than 0.9 kg (2.0 lbs.); time in traction sh\
ould start at 4 to 6 hours per
day. After the regimen of the first 2-3 weeks, increase the tension to b\
etween 0.9 kg and 1.2
kg; daily use should increase to 8-12 hours. You should wear the device \
for 10-12 hours per
day for 3-6 months to gain acceptable results.
Fig. 6. The "Home Hardware Extender" when worn. Note the sterile gauze r\
olled around the
head of the penis, and the metal paper binder clip (underneath the PVC \
"half-shell") holding
the tubing in place.
Check the color and temperature and feeling of the glans periodically. I\
f it turns blue or cold
or numb remove the device immediately, wait 10 minutes and reattach, mak\
ing sure that the
fit is not as snug, or the extension not as severe. If the noose is atta\
ched correctly, erections
should not pose any problem, since as the penis grows, the pull will les\
sen, and the Latex
tubing will expand when the head swells. Sometimes the penis will slip o\
ut of the Extender,
but given correct placement of the Gauze this should not pose a danger.
As with other "Extenders," if traction is more than about 1.0 kg (2.2 l\
bs.) of pull or more, the
device should be worn continuously for no more than about 2 hours, with \
10-15 minute breaks
between sessions. Trimming the pubic hair to prevent snagging in the bas\
e-plate assembly is
also recommended. For many users, including the author, 1 to 1.5 hour se\
ssions are more
comfortable, if less convenient.
If wearing the device for over 2 hours (or overnight), exercise EXTREM\
E CAUTION. Do not
use more than 0.6 kg (1.3 lb.) of pull, and adjust the Surgical Tubing\
so it is as loose as
possible without the glans slipping out. Gently exercise the penis immed\
iately after use.
Involuntary detachment while sleeping may occur, but this should not be \
dangerous.

Other penis enlargement ideas
http://www.fortunecity.co.uk/village/loverslane/178/docs/other_ideas.htm\
(5 of 12) [8/21/2001 12:43:55 PM]

Hot compresses (towels soaked in hot water and wrung dry) may alleviat\
e some of the
discomfort encountered while wearing an Extender-Type Device, as might d\
irectly inserting
the penis into warm water. This can be done before, during, after, or be\
tween traction
sessions. Such "heat therapy treatment" will not only feel pleasant, it \
will also increase the
flow of blood to ligaments, nerves, tendons, and the small amount of mus\
cle tissue in the
penis. Some studies have even suggested that heat can increase the rate \
of tissue distraction.
APPENDIX A
Notes from the Author
I have used both the "Home Hardware Extender" and the "PeniStretcher." T\
here is little
difference in feeling upon the penis between the two. The PeniStretcher \
is lighter, smaller, has
more precision machined parts, and is a bit more comfortable where the h\
ead of the penis is
attached. The "Home Hardware Extender" is actually easier to attach to t\
he penis (the
"PeniStretcher" often requires three hands!), and is a bit more comfort\
able at the base where
the device rests against the pubic bone (the "PeniStretcher" often tear\
s pubic hairs and crimps
tissue from the scrotal sac). Both devices can be worn continuously and\
comfortably for at
least 2 hours if the stretch is not too severe. I wrap the head of my pe\
nis with surgical gauze
before wearing either device for added comfort. I also use hand lotion t\
o reduce the
discomfort of having the skin being snagged or pinched. I have worn the \
PeniStretcher when
sleeping with no ill effects. Urination when in traction is awkward, but\
not insurmountable. I
have never experienced any bruises, bleeding, serious pain, or erectile \
difficulties that I could
attribute to the use of either device.
Erections were not adversely affected, indeed they often became harder (\
and of course longer)
than ever experienced before. Whether this is due to the placebo effect,\
experimental bias, or
the effects of actual tissue distraction or stretching of suspensory lig\
aments is unknown.
CONCLUSION: The gains may be valid, but extensive TIME must be devoted t\
o achieve
measurable, much less acceptable, results. It is unknown whether the rat\
e will increase or
decrease over time, or whether the results will even be permanent. I enc\
ourage others to
improve upon the ergonomics of my device.
Foam pipe insulation ('Shafter')
This device
Continue reading on your phone by scaning this QR Code

 / 22
Tip: The current page has been bookmarked automatically. If you wish to continue reading later, just open the Dertz Homepage, and click on the 'continue reading' link at the bottom of the page.