The Whitehouse Cookbook (1887) | Page 4

Mrs. F.L. Gillette
as is the case of all well-carved meats. The root of the tongue is usually left on the platter.
[Illustration]
BREAST OF VEAL.
This piece is quite similar to a fore-quarter of lamb after the shoulder has been taken off. A breast of veal consists of two parts, the rib-bones and the gristly brisket. These parts may be separated by sharply passing the carving knife in the direction of the line from 1 to 2; and when they are entirely divided, the rib-bones should be carved in the direction of the line from 5 to 6, and the brisket can be helped by cutting slices from 3 to 4.
The carver should ask the guests whether they have a preference for the brisket or ribs; and if there be a sweetbread served with the dish, as is frequently with this roast of veal, each person should receive a piece.
Though veal and lamb contain less nutrition than beef and mutton, in proportion to their weight, they are often preferred to these latter meats on account of their delicacy of texture and flavor. A whole breast of veal weighs from nine to twelve pounds.
[Illustration]
A FILLET OF VEAL.
A fillet of veal is one of the prime roasts of veal; it is taken from the leg above the knuckle; a piece weighing from ten to twelve pounds is a good size and requires about four hours for roasting. Before roasting, it is dressed with a force meat or stuffing placed in the cavity from where the bone was taken out and the flap tightly secured together with skewers; many bind it together with tape.
To carve it, cut in even thin slices off from the whole of the upper part or top, in the same manner as from a rolled roast of beef, as in the direction of the figs. 1 and 2; this gives the person served some of the dressing with each slice of meat.
Veal is very unwholesome unless it is cooked thoroughly, and when roasted should be of a rich brown color. Bacon, fried pork, sausage-balls, with greens, are among the accompaniments of roasted veal, also a cut lemon.
[Illustration]
NECK OF VEAL.
The best end of a neck of veal makes a very good roasting-piece; it, however, is composed of bone and ribs that make it quite difficult to carve, unless it is done properly. To attempt to carve each chop and serve it, you would not only place too large a piece upon the plate of the person you intend to serve, but you would waste much time, and should the vertebr? have not been removed by the butcher, you would be compelled to exercise such a degree of strength that would make one's appearance very ungraceful, and possibly, too, throwing gravy over your neighbor sitting next to you. The correct way to carve this roast is to cut diagonally from fig. 1 to 2, and help in slices of moderate thickness; then it may be cut from 3 to 4, in order to separate the small bones; divide and serve them, having first inquired if they are desired.
This joint is usually sent to the table accompanied by bacon, ham, tongue, or pickled pork, on a separate dish and with a cut lemon on a plate. There are also a number of sauces that are suitable with this roast.
[Illustration]
LEG OF MUTTON.
The best mutton, and that from which most nourishment is obtained is that of sheep from three to six years old, and which have been fed on dry, sweet pastures; then mutton is in its prime, the flesh being firm, juicy, dark colored and full of the richest gravy. When mutton is two years old, the meat is flabby, pale and savorless.
In carving a roasted leg, the best slices are found by cutting quite down to the bone, in the direction from 1 to 2, and slices may be taken from either side.
Some very good cuts are taken from the broad end from 5 to 6, and the fat on this ridge is very much liked by many. The cramp-bone is a delicacy, and is obtained by cutting down to the bone at 4, and running the knife under it in a semicircular direction to 3. The nearer the knuckle the drier the meat, but the under side contains the most finely grained meat, from which slices may be cut lengthwise. When sent to the table a frill of paper around the knuckle will improve its appearance.
[Illustration]
FORE-QUARTER OF LAMB.
The first cut to be made in carving a fore-quarter of lamb is to separate the shoulder from the breast and ribs; this is done by passing a sharp carving knife lightly around the dotted line as shown by the figs. 3, 4 and 5, so as to cut through the skin, and then, by raising with a little
Continue reading on your phone by scaning this QR Code

 / 279
Tip: The current page has been bookmarked automatically. If you wish to continue reading later, just open the Dertz Homepage, and click on the 'continue reading' link at the bottom of the page.