The Whitehouse Cookbook (1887) | Page 2

FOOD 473 VEGETABLES 191
[Illustration: HELEN HERRON TAFT. Copyright, Photo Clinediust,

Washington.]

WHITE HOUSE COOK BOOK.

CARVING.
Carving is one important acquisition in the routine of daily living, and
all should try to attain a knowledge or ability to do it well, and withal
gracefully.
When carving use a chair slightly higher than the ordinary size, as it
gives a better purchase on the meat, and appears more graceful than
when standing, as is often quite necessary when carving a turkey, or a
very large joint. More depends on skill than strength. The platter should
be placed opposite, and sufficiently near to give perfect command of
the article to be carved, the knife of medium size, sharp with a keen
edge. Commence by cutting the slices thin, laying them carefully to one
side of the platter, then afterwards placing the desired amount on each
guest's plate, to be served in turn by the servant.
In carving fish, care should be taken to help it in perfect flakes; for if
these are broken the beauty of the fish is lost. The carver should
acquaint himself with the choicest parts and morsels; and to give each
guest an equal share of those tidbits should be his maxim. Steel knives
and forks should on no account be used in helping fish, as these are
liable to impart a very disagreeable flavor. A fish-trowel of silver or
plated silver is the proper article to use.
Gravies should be sent to the table very hot, and in helping one to
gravy or melted butter, place it on a vacant side of the plate, not pour it
over their meat, fish or fowl, that they may use only as much as they
like.
When serving fowls, or meats, accompanied with stuffing, the guests
should be asked if they would have a portion, as it is not every one to

whom the flavor of stuffing is agreeable; in filling their plates, avoid
heaping one thing upon another, as it makes a bad appearance.
A word about the care of carving knives: a fine steel knife should not
come in contact with intense heat, because it destroys its temper, and
therefore impairs its cutting qualities. Table carving knives should not
be used in the kitchen, either around the stove, or for cutting bread,
meats, vegetables, etc.; a fine whetstone should be kept for sharpening,
and the knife cleaned carefully to avoid dulling its edge, all of which is
quite essential to successful carving.
* * * * *
[Illustration]
BEEF.
HIND-QUARTER.
No. 1. Used for choice roasts, the porterhouse and sirloin steaks.
No. 2. Rump, used for steaks, stews and corned beef.
No. 3. Aitch-bone, used for boiling-pieces, stews and pot roasts.
No. 4. Buttock or round, used for steaks, pot roasts, beef _á la mode_;
also a prime boiling-piece.
No. 5. Mouse-round, used for boiling and stewing.
No. 6. Shin or leg, used for soups, hashes, etc.
No. 7. Thick flank, cut with under fat, is a prime boiling-piece, good
for stews and corned beef, pressed beef.
No. 8. Veiny piece, used for corned beef, dried beef.
No. 9. Thin flank, used for corned beef and boiling-pieces.

FORE-QUARTER.
No. 10. Five ribs called the fore-rib. This is considered the primest
piece for roasting; also makes the finest steaks.
No. 11. Four ribs, called the middle ribs, used for roasting.
No. 12. Chuck ribs, used for second quality of roasts and steaks.
No. 13. Brisket, used for corned beef, stews, soups and spiced beef.
No. 14. Shoulder-piece, used for stews, soups, pot-roasts, mince-meat
and hashes.
Nos. 15, 16. Neck, clod or sticking-piece used for stocks, gravies,
soups, mince-pie meat, hashes, bologna sausages, etc.
No. 17. Shin or shank, used mostly for soups and stewing.
No. 18. Cheek.
The following is a classification of the qualities of meat, according to
the several joints of beef, when cut up.
First Class.--Includes the sirloin with the kidney suet (1), the rump
steak piece (2), the fore-rib (11).
Second Class.--The buttock or round (4), the thick flank (7), the middle
ribs (11).
Third Class.--The aitch-bone (3), the mouse-round (5), the thin flank (8,
9), the chuck (12), the shoulder-piece (14), the brisket (13).
Fourth Class.--The clod, neck and sticking-piece (15, 16).
Fifth Class.--Shin or shank (17).
[Illustration]

VEAL.
HIND-QUARTER.
No. 1. Loin, the choicest cuts used for roasts and chops.
No. 2. Fillet, used for roasts and cutlets.
No. 3. Loin, chump-end used for roasts and chops.
No. 4. The hind-knuckle or hock, used for stews, pot-pies, meat-pies.
FORE-QUARTER.
No. 5. Neck, best end used for roasts, stews and chops.
No. 6. Breast, best end used for roasting, stews and chops.
No. 7. Blade-bone, used for pot-roasts and baked dishes.
No. 8. Fore-knuckle, used for soups and stews.
No. 9. Breast, brisket-end used for