The Lobster Fishery of Maine | Page 6

John N. Cobb
southeast of Pemaquid Point, agree among themselves to put no lobster pots in the water until about the 1st of January. There is then no restriction on fishing until about May 15, when all pots are hauled out and no more fishing is done until the season begins again. During this season the law in regard to short lobsters is rigidly enforced by the fishermen themselves. Should any outsider visit this island during the close time established by the fishermen, and attempt to fish, he is quietly informed of the agreement and requested to conform to it. Should he persist in working after this warning, his pots are apt to mysteriously disappear. As lobsters bring a much higher price in winter than in summer, the Monhegan fishermen reap a rich reward, as the lobsters are very numerous, owing to the 7-1/2 months close time. On the first day the fishermen hauled in 1900 one man secured 293, for which he received 19 cents apiece. The smallest number secured by anyone was 135.

FISHING APPLIANCES.
In most large fisheries for certain species numerous changes occur at intervals in the apparatus used, owing to changed conditions, etc., but in the lobster industry changes have been few, and at an early period the fishermen fixed upon a uniform apparatus, which has been in use ever since with but slight modifications, and these generally only temporary.
The earliest form of apparatus used to any considerable extent was the hoop net. This consisted generally of a hoop or ring of about 1/2-inch round iron, or a wooden hogshead hoop, from 2-1/2 to 3 feet or more in diameter. To this hoop was attached a net bag with a depth of 18 to 24 inches as a bottom, while two wooden half hoops were bent above it, crossing at right angles in the center about 12 or 15 inches above the plane of the hoop. Sometimes these half hoops were replaced by short cords. The bait was suspended from the point of crossing of the two wooden hoops and the line for raising and lowering the pots was attached at the same place. As there was no way of closing the mouth of the pot after a lobster had entered, these nets had to be constantly watched, the lobster being in the habit of retiring after he had finished his repast. In using these the fisherman would generally go out in the evening and at short intervals he would haul in his nets and remove whatever lobsters they might contain. The constant attention necessary in attending to these hoop nets led the fishermen to devise an apparatus which would hold the lobsters after once entering and would require only occasional visits, and "lath pots" were found to fulfill all requirements. They acquire the name from the use of common laths in their construction. They are usually about 4 feet in length, with a width of about 2 feet, a height of 18 inches, and in Maine are usually of semicylindrical form.
The following description of this apparatus is from the Fishery Industries of the United States, sec. v, vol. 11, p. 666:
The framework of the bottom consists of three strips of wood, either hemlock, spruce, or pine (the first mentioned being the most durable), a little longer than the width of the pot, about 2-3/4 inches wide and 1 inch thick. In the ends of each of the outer strips a hole is bored to receive the ends of a small branch of pliable wood, which is bent into a regular semicircular curve. These hoops are made of branches of spruce or hemlock, or of hardwood saplings, such as maple, birch, or ash, generally retaining the bark. Three of these similar frames, straight below and curved above, constitute the framework of each pot, one to stand at each end and one in the center. The narrow strips of wood, generally ordinary house laths of spruce or pine, which form the covering, are nailed lengthwise to them, with interspaces between about equal to the width of the lathe. On the bottom the laths are sometimes nailed on the outside and sometimes on the inside of the cross pieces. The door is formed by three or four of the laths running the entire length near the top. The door is hinged on by means of small leather strips, and is fastened by a single wooden button in the center, or by two buttons, one at each end. The openings into the pot . . . are two in number, one at each end, are generally knit of coarse twine and have a mesh between three-fourths of an inch and 1 inch square. They are funnel-shaped, with one side shorter than the other, and at the larger end have the same diameter as
Continue reading on your phone by scaning this QR Code

 / 25
Tip: The current page has been bookmarked automatically. If you wish to continue reading later, just open the Dertz Homepage, and click on the 'continue reading' link at the bottom of the page.