The Art of Making Whiskey | Page 9

are volatile, and evaporate easily. They must therefore be managed carefully, in order not to lose the fruits of an already tedious labor. The spirit already created in the fermented liquor, must be collected by the distillation; but in transporting it to the still, the action of the external air must be carefully avoided, as it would cause the evaporation of some of the spirit. A pump to empty the hogsheads, and covered pipes to conduct the liquor into the still, is what has been found to answer that purpose. A good distilling apparatus is undoubtedly the most important part of a distillery. It must unite solidity, perfection in its joints, economy of fuel, rapidity of distillation, to the faculty of concentrating the spirit. Such are the ends I have proposed to myself in the following apparatus.
The usual shape of stills is defective; they are too deep, and do not present enough of surface for their contents. They require a violent fire to bring them to ebullition; the liquor at bottom burns before it is warm at the top.
My still is made upon different principles, and composed of two pieces, viz. the kettle, and its lid. The kettle, forming a long square, is like the kettle of infusion, already described, and only differs from it in being one foot deeper. The lid is in shape like an ancient bed tester; that is to say, its four corners rise into a sharp angle, and come to support a circle 16 inches diameter, bearing a vertical collar of about two inches. This collar comes to the middle of the kettle, and is elevated about 4 feet from the bottom. The lid is fastened to the kettle. The collar receives a pewter cap, to which is joined a pipe of the same metal, the diameter of which decreases progressively to a little less than 3 inches: this pipe, the direction of which is almost horizontal, is 5 feet long.
My still, thus constructed, is established upon a furnace like that of the infusion room. I observe that the side walls are only raised to the half of the height of the kettle. A vertical pipe is placed on the side opposite to the pewter one, and serves to fill up the still: it is almost at the height of the fastening of the lid, but a little above. On the same side, on a level with the bottom, is a pipe of discharge, passing across the furnace: this pipe must project enough to help to receive or to direct the fluid residue of the distillation; its diameter must be such as to operate a prompt discharge of the still.
OF THE URNS.
These are copper vessels, thus called from their resembling those funeral vases of the ancients. Mine have a bottom of about 18 inches diameter; they are two feet high, have a bulge of 6 inches near the top, and then draw in to form an overture of about 8 inches.
On one side, towards the top, there is a copper pipe 2 inches diameter, projecting externally 2 or 3 inches, and bent in an elbow: it enters the internal part of the urn, and descends towards the bottom, without touching it; there it is only a slight curve, and remains open.
The external part of that pipe is fitted to receive the pewter pipe of the still; they are made so as to enter into one another, and must fit exactly. The round opening at the top of the urn receives a cap with a pewter pipe, made like that of the still. It is likewise five feet long, and its size in proportion to the opening: this goes and joins itself to the second urn, as the still does to the first. The pipe of this second goes to a third, and the pipe of this last to the worm. The three urns bear each a small pipe of discharge towards the bottom.
This apparatus must be made with the greatest care. Neither the joints, the different pipes of communication, nor the nailings, must leave the smallest passage to the vapors. The workman must pay the greatest attention to his work, and the distiller must lute exactly all the parts of the apparatus that are susceptible of it: he must be the more careful as to luting it, as this operation is only performed once a week, when the apparatus is cleaned. At the moment of the distillation, the master or his foreman must carefully observe whether there is any waste of vapors, and remedy it instantly. The still and urns ought to be well tinned.
CHAPTER XII.
EFFECTS OF THIS APPARATUS.
Although the still might contain 400 gallons, there must be only 200 gallons put into it: the rest remaining empty, the vapors develops themselves, and rise. In