The American Practical Brewer and Tanner | Page 7

heaped to any depth without injury or danger of breaking down. Malt thus kept, if well dried before coming off the kiln, is never in danger of heating or getting slack. The common mode of keeping malt is in bins situated on upper lofts, often injured by leaks from the roof, and at all times liable to the depredations of rats, which in the other way can be effectually guarded against, and is a highly important object of precaution to be taken by the brewer. Should weevils at any time get into, or generate in your malt, which is common when held over beyond twelve or eighteen months, the simplest and easiest way of getting rid of them, is to place four or five lobsters on your heap of malt, the smell of which will soon compel the weevils to quit the malt, and take refuge on the walls, from which they can be swept with a broom into a sheet or table cloth laid on the malt, and so taken off. It is asserted, that by this simple contrivance not one weevil will remain in the heap. Malt intended for brewing should be always screened before grinding; and for this purpose it is a good contrivance to screen it by means of the horse mill, as it runs from the hopper to the rollers or stones to be ground, the expense of which apparatus is comparatively nothing when compared to the advantages arising from it.
[2] By some this construction of a steep may be thought too dear; in that case, a rough wooden one may be substituted, which, instead of placing outside the house, I would place on the upper floor of the malt house, so as to afford the opportunity of getting down its contents to the lower floor by means of a plug hole, which will save the labour of shovelling; but in summer, when this steep is not employed, it should be filled with lime water to prevent leaking, and to keep it sweet.

Wooden Kilns, how constructed.
The best form for these kilns is the circular. I will suppose the diameter sixteen feet; you construct your fire-place suitably to the burning of wood at about ten feet outside your kiln house, sufficiently elevated on iron bars to secure the draft of the fire place, from which runs a proportionate sized flue into the kiln, communicating with a circular flue which is close covered at top, and rounds the kiln on the inside at the distance of two feet from the wall; on both sides of this circular flue holes are left, at the distance of twelve or sixteen inches apart, on both sides, to let out the smoke and heat; the platform or floor of this kiln is raised about four or five feet above the top of the flue, and is made of three quarter inch boards, tongued and grooved, supported by joists two inches broad, and nine inches deep, placed at proportioned distances, to give solidity to the floor. The floor or platform of this kiln should be carefully laid, and well nailed; in this floor should be placed a wooden chimney, nine inches square, on the most convenient part of the inside next the wall, with a wooden register at a convenient distance: this chimney is intended to let off the great smoke that arises in the kiln at first lighting fire, particularly if the wood be moist or green. When this has gone off, and the fire burns clear, the register may be shut within a few inches, in order to keep up a small draft. It would have been proper to state that joists, intended to support the floor of this kiln, should be levelled off to one inch, top and bottom, so as give the fire a better chance to act upon the malt; these joists should be further paid as soon as, or before, laying down, with a strong solution of alum water; as also the bottom face of the boards laid on them, which should be first planed; the inside of the chimney and register should be also paid with the alum solution. On the top of the kiln should be placed a ventilator to draw off the steam of the malt, this may be done by means of a loover or cow; the latter turns with the wind, the former is stationary.
There should be skirting boards, nine inches deep, to lie close to the floor and walls of the kiln, plastered with hair mortar on the top. This construction of kiln has been introduced by the Dutch, and will be found the most economical of any, joined to the peculiar advantage of being capable of drying malt with any kind of fuel, without danger of communicating any sort