to begin with, a gas pipe of 1 inch internal diameter is fixed along the outside of the boiler, and at about the middle of its length it is fitted with a three-way cock having a screw nipple and cap. The front end of the longitudinal pipe is connected to the blower in the chimney, and the back end is attached to the spray injector. Then by connecting to the nipple a pipe from a shunting locomotive under steam, the spray jet is immediately started by the borrowed steam, by which at the same time a draught is also maintained in the chimney. In a fully equipped engine shed the borrowed steam would be obtained from a fixed boiler conveniently placed and specially arranged for the purpose of raising steam. In practice steam can be raised from cold water to 3 atm. pressure--45 lb. per square inch--in twenty minutes. The use of auxiliary steam is then dispensed with, and the spray jet is worked by steam from its own boiler; a pressure of 8 atm.--120 lb.--is thus obtained in fifty to fifty-five minutes from the time the spray jet was first started. In daily practice, when it is only necessary to raise steam in boilers already full of hot water, the full pressure of 7 to 8 atm. is obtained in from twenty to twenty-five minutes. While experimenting with liquid fuel for locomotives, a separate tank was placed on the tender for carrying the petroleum, having a capacity of about 3 tons. But to have a separate tank on the tender, even though fixed in place, would be a source of danger from the possibility of its moving forward in case of collision. It was therefore decided, as soon as petroleum firing was permanently introduced, to place the tank for fuel in the tender between the two side compartments of the water tank, utilizing the original coal space. For a six-wheeled locomotive the capacity of the tank is 3-1/2 tons of oil--a quantity sufficient for 250 miles, with a train of 480 tons gross exclusive of engine and tender. In charging the tender tank with petroleum, it is of great importance to have strainers of wire cloth in the manhole of two different meshes, the outer one having openings, say, of 1/4 in., the inner, say 1/8 in.; these strainers are occasionally taken out and cleaned. If care be taken to prevent any solid particles from entering with the petroleum, no fouling of the spray injector is likely to occur; and even if an obstruction should arise, the obstacle being of small size can easily be blown through by screwing back the steam cone in the spray injector far enough to let the solid particles pass and be blown out into the fire-box by the steam. This expedient is easily resorted to even when running; and no more inconvenience arises than an extra puff of dense smoke for a moment, in consequence of the sudden admission of too much fuel. Besides the two strainers in the manhole of the petroleum tank on the tender, there should be another strainer at the outlet valve inside the tank, having a mesh of 1/3 in. holes.
Driving locomotives.--In lighting up, certain precise rules have to be followed, in order to prevent explosion of any gas that may have accumulated in the fire box. Such explosions do often take place through negligence; but they amount simply to a puff of gas, driving smoke out through the ash-pan dampers, without any disagreeably loud report. This is all prevented by adhering to the following simple rules: First clear the spray nozzle of water by letting a small quantity of steam blow through, with the ash-pan doors open; at the same time start the blower in the chimney for a few seconds, and the gas, if any, will be immediately drawn up the chimney. Next place on the bottom of the combustion chamber a piece of cotton waste, or a handful of shavings saturated with petroleum and burning with a flame. Then by opening first the steam valve of the spray injector, and next the petroleum valve gently, the very first spray of oil coming on the flaming waste immediately ignites without any explosion whatever; after which the quantity of fuel can be increased at pleasure. By looking at the top of the chimney, the supply of petroleum can be regulated by observing the smoke. The general rule is to allow a transparent light smoke to escape, thus showing that neither too much air is being admitted nor too little. The combustion is quite under the control of the driver, and the regulation can be so effected as to prevent smoke altogether. While running, it is indispensable that the driver and fireman should act together, the latter having
Continue reading on your phone by scaning this QR Code
Tip: The current page has been bookmarked automatically. If you wish to continue reading later, just open the
Dertz Homepage, and click on the 'continue reading' link at the bottom of the page.