of Hugo Muller (bromine water) and Cross and Bevan (chlorine gas). Lastly, the authors notice the methods based upon the action of the alkaline hydrates at high temperatures (180��) in presence of water (Lange), or of glycerin (Gabriel). The process of heating to 210�� with glycerin only (H?nig) yields a very impure and ill-defined product.
For comparative investigation of these processes certain celluloses and cellulosic materials were prepared as follows:
(a) 'Rag' cellulose.--A chemical filter paper, containing only cotton and linen celluloses, was further purified by boiling with dilute acid and dilute alkali. After thorough washing it was air-dried.
(b) Wood cellulose.--Pine wood sawdust was treated by digestion for fourteen days with dilute nitric acid with addition of chlorate (Schulze). The mass was washed and digested with alkaline lye (1.25 p.ct. KOH), and exhaustively washed, treated with dilute acetic acid; again washed, and finally air-dried.
This product was found to yield 2.3 p.ct. furfural on distillation with HCl (1.06 sp.gr.).
(c) Purified wood.--Pine wood sawdust was treated in succession with dilute alkalis and acids, in the cold, and with alcohol and ether until exhausted of products soluble in these liquids and reagents.
In addition to the above the authors have also employed jute fibre and raw cotton wool in their investigations.
They note that the yield of cellulose is in many cases sensibly lowered by treating the material after drying at the temperature of 100��. The material for treatment is therefore weighed in the air-dry condition, and a similar sample weighed off for drying at 100�� for determination of moisture.
The main results of the experimental investigation are as follows:--
Weende process further attacks the purified celluloses as follows: Wood cellulose losing in weight 8-9 p.ct.; filter paper, 6-7.5 p.ct., and the latter treated a second time loses a further 4-5 p.ct. It is clear, therefore, that the process is of purely empirical value.
Schulze.--This process gave a yield of 47.6 p.ct. cellulose from pine wood. The celluloses themselves, treated by the process, showed losses of 1-3 p.ct. in weight, much less therefore than in the preceding case.
H?nig's method of heating with glycerin to 210�� was found to yield products very far removed from 'cellulose.' The process may have a certain value in estimations of 'crude fibre,' but is dismissed from further consideration in relation to cellulose.
Lange.--The purpose of the investigation was to test the validity of the statement that the celluloses are not attacked by alkaline hydrates at 180��. Experiments with pine wood yielded a series of percentages for cellulose varying from 36 to 41; the 'purified wood' gave also variable numbers, 44 to 49 per cent. It was found possible to limit these variations by altering the conditions in the later stages of isolating the product; but further experiments on the celluloses themselves previously isolated by other processes showed that they were profoundly and variably attacked by the 'Lange' treatment, wood cellulose losing 50 per cent. of its weight, and filter paper (cellulose) losing 15 per cent. Further, a specimen of jute yielded 58 per cent. of cellulose by this method instead of the normal 78 per cent. It was also found that the celluloses isolated by the process, when subjected to a second treatment, underwent a further large conversion into soluble derivatives, and in a third treatment further losses of 5-10 per cent were obtained. The authors attach value, notwithstanding, to the process which they state to yield an 'approximately pure cellulose,' and they describe a modified method embodying the improvements in detail resulting from their investigation.
Gabriel's method of heating with a glycerin solution of alkaline hydrate is a combination of 'H?nig' and 'Lange.' An extended investigation showed as in the case of the latter that the celluloses themselves are more or less profoundly attacked by the treatment--further that the celluloses isolated from lignocelluloses and other complex raw materials are much 'less pure' than those obtained by the Lange process. Thus, notably in regard to furfural yielding constituents, the latter yield 1-2 p.ct. furfural, whereas specimens of 'jute cellulose' obtained by the Gabriel process were found to yield 9 to 13 p.ct. furfural.
Cross and Bevan.--Chlorination process yielded in the hands of the authors results confirming the figures given in 'Cellulose' for yield of cellulose. Investigation of the products for yield of furfural, gave 9 p.ct. of this aldehyde showing the presence of celluloses, other than the normal type.
Conclusions.--The subjoined table gives the mean numerical results for yield of end-product or 'cellulose' by the various methods. In the case of the 'celluloses' the results are those of the further action of the several processes on the end-product of a previous process.
| Methods | F. Schulze | Weende | Lange | Gabriel | Cross | | | | | and Bevan -------------------------------------------------------------------------- Wood cellulose | 98.51 | 91.52 | 48.22 | 55.93 | -- Filter paper cellulose | 99.62
![](qr/33060/8.png)
Continue reading on your phone by scaning this QR Code
Tip: The current page has been bookmarked automatically. If you wish to continue reading later, just open the
Dertz Homepage, and click on the 'continue reading' link at the bottom of the page.