Gardening Without Irrigation: or without much, anyway | Page 7

Steve Solomon
increase the amount of water that could adhere to the original material. Clay particles, it should be noted, are so small that clay's ability to hold water is not as great as its mathematically computed surface area would indicate.
Surface Area of One Gram of Soil Particles
Particle type Diameter of particles in mm Number of particles per gm Surface area in sq. cm.
Very coarse sand 2.00-1.00 90 11 Coarse sand 1.00-0.50 720 23 Medium sand 0.50-0.25 5,700 45 Fine sand 0.25-0.10 46,000 91 Very fine sand 0.10-0.05 772,000 227 Silt 0.05-0.002 5,776,000 454 Clay Below 0.002 90,260,853,000 8,000,000
Source: Foth, Henry D., _Fundamentals of Soil Science,_ 8th ed.
(New York: John Wylie & Sons, 1990).
This direct relationship between particle size, surface area, and water-holding capacity is so essential to understanding plant growth that the surface areas presented by various sizes of soil particles have been calculated. Soils are not composed of a single size of particle. If the mix is primarily sand, we call it a sandy soil. If the mix is primarily clay, we call it a clay soil. If the soil is a relatively equal mix of all three, containing no more than 35 percent clay, we call it a loam.
Available Moisture (inches of water per foot of soil)
Soil Texture Average Amount Very coarse sand 0.5 Coarse sand 0.7 Sandy 1.0 Sandy loam 1.4 Loam 2.0 Clay loam 2.3 Silty clay 2.5 Clay 2.7
Source: Fundamentals of Soil Science.
Adhering water films can vary greatly in thickness. But if the water molecules adhering to a soil particle become too thick, the force of adhesion becomes too weak to resist the force of gravity, and some water flows deeper into the soil. When water films are relatively thick the soil feels wet and plant roots can easily absorb moisture. "Field capacity" is the term describing soil particles holding all the water they can against the force of gravity.
At the other extreme, the thinner the water films become, the more tightly they adhere and the drier the earth feels. At some degree of desiccation, roots are no longer forceful enough to draw on soil moisture as fast as the plants are transpiring. This condition is called the "wilting point." The term "available moisture" refers to the difference between field capacity and the amount of moisture left after the plants have died.
Clayey soil can provide plants with three times as much available water as sand, six times as much as a very coarse sandy soil. It might seem logical to conclude that a clayey garden would be the most drought resistant. But there's more to it. For some crops, deep sandy loams can provide just about as much usable moisture as clays. Sandy soils usually allow more extensive root development, so a plant with a naturally aggressive and deep root system may be able to occupy a much larger volume of sandy loam, ultimately coming up with more moisture than it could obtain from a heavy, airless clay. And sandy loams often have a clayey, moisture-rich subsoil.
_Because of this interplay of factors, how much available water your own unique garden soil is actually capable of providing and how much you will have to supplement it with irrigation can only be discovered by trial._
How Soil Loses Water
Suppose we tilled a plot about April 1 and then measured soil moisture loss until October. Because plants growing around the edge might extend roots into our test plot and extract moisture, we'll make our tilled area 50 feet by 50 feet and make all our measurements in the center. And let's locate this imaginary plot in full sun on flat, uniform soil. And let's plant absolutely nothing in this bare earth. And all season let's rigorously hoe out every weed while it is still very tiny.
Let's also suppose it's been a typical maritime Northwest rainy winter, so on April 1 the soil is at field capacity, holding all the moisture it can. From early April until well into September the hot sun will beat down on this bare plot. Our summer rains generally come in insignificant installments and do not penetrate deeply; all of the rain quickly evaporates from the surface few inches without recharging deeper layers. Most readers would reason that a soil moisture measurement taken 6 inches down on September 1, should show very little water left. One foot down seems like it should be just as dry, and in fact, most gardeners would expect that there would be very little water found in the soil until we got down quite a few feet if there were several feet of soil.
But that is not what happens! The hot sun does dry out the surface inches, but if we dig down 6 inches or so there will be almost as much water present in September as there was in
Continue reading on your phone by scaning this QR Code

 / 34
Tip: The current page has been bookmarked automatically. If you wish to continue reading later, just open the Dertz Homepage, and click on the 'continue reading' link at the bottom of the page.